a Problem with my Sine wave Signal

Hello everyone, I am doing a simulation on CircuitLab, and its the sine wave starts at 9 instead of 0V in the timestamp simulation, although I have used the exact same circuit on LTspice and Multisim and I didn't have that problem. when I hover over the Óutput capacitor it says 0 V. And I also encountered the exact same problem on Qspice. any suggestions? Thank you

by maly53
March 04, 2024

Post a Reply

Please sign in or create an account to comment.

Go Ad-Free. Activate your CircuitLab membership. No more ads. Save unlimited circuits. Run unlimited simulations.

About CircuitLab

CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.

New @ CircuitLab
Foxx commented on question: "Vacuum Tubes" 2 hours ago
JHCPSE saved circuit: "Extra Credit Circuit" 3 hours ago
RonSim saved circuit: "rectifier"
CraigRobi asked: "Vacuum Tubes"
MatthewAllbert started discussion: "N Channel MOSFET Not Connecting to..."
leobarlas started discussion: "changing component value"
vanderghast commented on question: "oscillator wont simulate correctly"
Stevewill62 asked: "24 volt controller to 12 volt load"
Dan.Ka started discussion: "CircuitLab example wrong?"
DFinamore commented on question: "Transformer model with CT primary..."
plshelpadummy asked: "Trying to make a DIY 10000 lumen..."
maddiemueller asked: "oscillator wont simulate correctly"
danialusk commented on an answer to: "Create your own diagram of 4 bulbs..."
vanderghast answered: "custom components"
eachhabitual answered: "photocoupler"
Foxx answered: "3 phase power supply"
sgeorgia answered: "Relays on a chip"
swipesy started discussion: "Resetting part auto numbering"
CircuitLab Blog: "Live DC Simulation!"
CircuitLab Blog: "Digital Adders and Wider Muxes"

Forums » CircuitLab Support Forum