Forums » CircuitLab Support Forum

Hi Circuit lab community,

Has anyone created a custom device for the LM108 op amp? I used supply rails of +/- 15V in lab and the datasheet values are for +/- 20. Has anyone created one already?

Also, how can I adjust compensation between pins 1 and 8, it seems circuit lab only allows for input, output, and supply rails? I'm a little confused.

Thanks for any help anyone can provide!

-Rich

Thanks Signality. I went with 741's instead. Actually is there any chance you can check something for me? I built a sine wave oscillator in lab and now I'm trying to model it on here. I had it working at some point with sin and cosine waveforms and now I'm just getting a charge up to the supply rail DC signal. It seems very weird and I'm sure there is some minor mistake that I made and now can't seem to pick up on it myself. All of the component values are the same as when I built it.

https://www.circuitlab.com/circuit/stg944/low-frequency-sine-wave-generator-with-quadrative-output/

Thanks for any help you can provide