Forums » General Electronics Discussion

This is really dumb but how do you make one wire bridge another one (with the little hump)?

This depends on the drawing software you are using. I use EDraw7 and by using "Basic tools--Connector" the bridge with no connection is automatic. Where I made a living for many years we sidestepped the question by never using the bridge crossover. Two lines simply crossing were never connected. If a connection was desired it could be shown by a dot at the crossover.

I want to use C1815 transistors in my circuit. Jameco doesn't stock it so I don't know how to add the Spice parameters. I'm trying to repurpose the parts out of old CRT televisions.

I figured it out. Thanks.

It's surprising what you can learn by battering your head against a brick wall

So, how do you do it? I have wasted the past 2 hours trying to figure this out, I'm going crazy :(