|
Hello. I wanted to build a circuit operating at 9V with a microcontroller operating at a maximum of 5.5V. Will it be okay if I use a voltage divider to power it? Thank you in advance for your help |
November 12, 2024 |
|
Probably no. If you place the MCU in parallel with one of the resistors, you need small resistors so the the resistivity of the MCU in parallel with its resistor won't change much if the resistivity of the MCU changes. That means that you will lose a lot of energy through the small resistances. But consider too that the MCU may not require a constant current and if it requires a large amount of it, you don't have a voltage divider anymore since it is not the same current running trough both resistors anymore. So your supplied voltage to the MCU may varies and invalidate some of its components, due to these fluctuations. I will try a TL431 instead, if your MCU don't ask for more than 100mA. The TL431 is a kind of Zener diode that you can specify its Vz value (with a nice sharp knee) by adding few components to it. See its datasheet. |
November 14, 2024 |
|
Thanks for 101 games post! |
November 18, 2024 |
| Add comment... | |
No answers yet. Contribute your answer below!
You must log in or create an account (free!) to answer a question.
Anyone can ask a question.
Did you already search (see above) to see if a similar question has already been answered? If you can't find the answer, you may ask a question.
CircuitLab's Q&A site is a FREE questions and answers forum for electronics and electrical engineering students, hobbyists, and professionals.
We encourage you to use our built-in schematic & simulation software to add more detail to your questions and answers.
Acceptable Questions:
Unacceptable Questions:
Please respect that there are both seasoned experts and total newbies here: please be nice, be constructive, and be specific!
CircuitLab is an in-browser schematic capture and circuit simulation software tool to help you rapidly design and analyze analog and digital electronics systems.
Please sign in or create an account to comment.