"spdt"-tagged Public Circuits

Now showing circuits 1-1 of 1. Sort by recently modified name

voltage controlled SPDT switch 01 PUBLIC Using two voltage controlled switches, a buffer, an inverter and a PWS() source to make a voltage controlled SPDT switch. Simulate > Time Domain > Run Time-Domain SImulation by signality | updated August 05, 2012 spdt   switch   voltage-controlled-switch

More tags

555   7805   ac-to-dc   active-filter   amplifier   analog   and   anode   attenuator   atx   audio   automotive   band-reject   bandgap   behavioral   bias-point   bjt   bode   bridge-rectifier   button   calculator   cascaded-filters   cascode   cathode   cmos   colpitts   compensation   constant-current-source   current-limiting   current-mirror   current-monitor   current-regulator   dac   dc-to-ac   device-modeling   differential   differentiator   digital   diode   divider   emitter-follower   feedback   filter   flyback   flyback-diode   frequency-domain   full-wave   guitar   ham-radio   high-pass   high-speed   high-voltage   hv   hysteresis   ic   ignition-coil   induction   inductive   inductive-load   initial-conditions   instrumentation-amplifier   integrator   inverting   jfet   laplace   led   led-array   level-shift   lighting   lipo   lm317   load-cell   logic-gate   low-pass   mechanical   microcontroller   microphone   mosfet   motor   multivibrator   non-inverting   nonlinear   nor   notch   ohms-law   op-amp   optical   or   oscillator   parallel   passive   passive-filter   pcb-design   phase-shift   photodiode   photoresistor   phototransistor   piezo   plants   potentiometer   power   power-supply   power-supply-unit   preamp   pull-down   pull-up   pwm   rc   relaxation-oscillator   relay   resistor-ladder   resonance   rf   rlc   rom   saturation   schmitt-trigger   sensor   series   servo-motor   signal   spark-plug   stability   stepper   summing   superposition   switching   time-constant   transformer   transistor   translinear   twin-t   voltage-divider   voltage-regulator   waveform-arithmetic   wiring   xnor   xor   zener-diode   zero-voltage-switching  

---

New @ CircuitLab
Hismandent commented on question: "9V to 5V conversion problems" 5 hours ago
WanderingLogic saved circuit: "bootstrap question"
matheusc3 saved circuit: "Estação Circuit"
robertmalone1 saved circuit: "Wheatstone bridge"
rtadams2 saved circuit: "project2"
BeverlyJClark answered: "9V for ATmega328P?"
vanderghast commented on question: "9V to 5V conversion problems"
R1ckRul3s asked: "Crystal Oscillator Circuit: DC/AC..."
hank2000 answered: "H-bridge for bistable solenoid"
dominica answered: "Led chaser power issue"
hank2000 asked: "H-bridge for bistable solenoid"
Lionsio asked: "9V to 5V conversion problems"
detailsizzling commented on an answer to: "How to Design a Circuit for..."
natastro started discussion: "Photodiode symbol: messed-up arrow"
vanderghast answered: "How to Design a Circuit for..."
AnushaIzhar asked: "Full wave rectifier"
krokoi commented on question: "how to represent a symetrical..."
b3organ replied to discussion: "Export a Parts list"
Jogibaer replied to discussion: "Vacuum Tube Models"
john_pa replied to discussion: "What am I doing wrong with this..."
CircuitLab Blog: "Live DC Simulation!"
CircuitLab Blog: "Digital Adders and Wider Muxes"