"pulse-width-modulator"-tagged Public Circuits

Now showing circuits 1-1 of 1. Sort by recently modified name

PWM 01 PUBLIC V(duty) sets the duty cycle of the PWM output. V(saw) is a 0 to 1V swing sawtooth and sets the PWM frequency. V(amp) sets the amplitude of the PWM output. V(offset) sets the DC offset of the PWM... by signality | updated July 28, 2012 pulse-width-modulator   pwm   variable-duty-cycle

More tags

555   7805   ac-to-dc   active-filter   amplifier   analog   and   anode   attenuator   atx   audio   automotive   band-reject   bandgap   behavioral   bias-point   bjt   bode   bridge-rectifier   button   calculator   cascaded-filters   cascode   cathode   cmos   colpitts   compensation   constant-current-source   current-limiting   current-mirror   current-monitor   current-regulator   dac   dc-to-ac   device-modeling   differential   differentiator   digital   diode   divider   emitter-follower   feedback   filter   flyback   flyback-diode   frequency-domain   full-wave   guitar   ham-radio   high-pass   high-speed   high-voltage   hv   hysteresis   ic   ignition-coil   induction   inductive   inductive-load   initial-conditions   instrumentation-amplifier   integrator   inverting   jfet   laplace   led   led-array   level-shift   lighting   lipo   lm317   load-cell   logic-gate   low-pass   mechanical   microcontroller   microphone   mosfet   motor   multivibrator   non-inverting   nonlinear   nor   notch   ohms-law   op-amp   optical   or   oscillator   parallel   passive   passive-filter   pcb-design   phase-shift   photodiode   photoresistor   phototransistor   piezo   plants   potentiometer   power   power-supply   power-supply-unit   preamp   pull-down   pull-up   pwm   rc   relaxation-oscillator   relay   resistor-ladder   resonance   rf   rlc   rom   saturation   schmitt-trigger   sensor   series   servo-motor   signal   spark-plug   stability   stepper   summing   superposition   switching   time-constant   transformer   transistor   translinear   twin-t   voltage-divider   voltage-regulator   waveform-arithmetic   wiring   xnor   xor   zener-diode   zero-voltage-switching  

---

New @ CircuitLab
Koen_Van_de_moortel started discussion: "Symbols badly missing"
jjmengineer saved circuit: "Photodiode Amp - Schmitt Trigger IC..."
Yacht69 saved circuit: "Te Vega Main Engine Control WIring..."
venkys saved circuit: "Subtracting Offset"
jjfelice saved circuit: "Hit_Decay_Hold2"
kwlyon replied to discussion: "I seem to have trouble with..."
jonathanzam answered: "Ohmmeter needed"
ramonhamil answered: "The Drag and Drop not working on..."
natastro answered: "Ohmmeter needed"
kwlyon asked: "I am on that peak of the Dunning..."
Grubb replied to discussion: "How to represent LM386 in schematic"
Matti428493 asked: "Ohmmeter needed"
abitofhelp asked: "BJT Base-Emitter Reverse Breakdown..."
Edmore asked: "pushbutton digital input signal..."
ErnestThornton answered: "triggered momentary switch"
Jiminvan replied to discussion: "Help needed - trying to simulate an..."
Hismandent commented on question: "9V to 5V conversion problems"
vanderghast commented on question: "9V to 5V conversion problems"
detailsizzling commented on an answer to: "How to Design a Circuit for..."
krokoi commented on question: "how to represent a symetrical..."
CircuitLab Blog: "Live DC Simulation!"
CircuitLab Blog: "Digital Adders and Wider Muxes"